Features
FEATURES: Construction: Elapor foam, color scheme consists of a white fuselage
with blue wings and tail section with yellow and white decal
accents
Wings: Two-piece foam with GRP tubular wing joiner
Radio Compartment: Easily accessible under wing
Motor: Speed 400 size with leads
Servos: Two micro size preinstalled with universal connectors for
rudder and elevator control
Hardware: Control horns, rods and all mounting hardware included
Motor Mount: Wing mounted plastic motor bracket
Electronic speed control, motor w/prop, and servos w/pushrods are
all preinstalled
INCLUDES: Elapor foam fuselage and wing halves, pushrods, 400 size motor
with connector board and cables, one propeller and spinner,
hardware package, tail section, decals, photo-illustrated
instructions
REQUIRES: Battery: 6 cell 900mAh
Using this battery will require cutting off the connectors of the
battery and speed control and soldering on Dean's 2-pin Ultra
Plugs to the battery and speed control. NOTE, care must
be taken when cutting off battery connector as the leads are very
short. Additional wire may be needed to lengthen leads
********************************************************************
** Please note the batteries listed in the manual are **
** Multiplex #'s (15 5545),(15 6019), and (15 5648). **
** These numbers are not available to us at this time. **
********************************************************************
Charger: Timed or peak
Radio: 3-Channel with micro receiver
Building and Field Equipment: Medium CA glue, activator, tools
SPECS: Wingspan: 54" (1370mm)
Wing Area: 371 sq in (24 sq dm)
Weight: 24 oz (680g) with 6 AA cells
Wing Loading: 9.17 oz/sq ft (28 g/sq dm)
Total Length: 36.1" (917mm)
Center of Gravity: 3.1" (78mm) from the wing's leading edge at the
fuselage sides.
Control Throws-
Elevator: Up-0.20" (5mm) Down-0.16" (4mm)
Rudder (left and right): 0.39" (10mm)
COMMENTS: This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with
an activator is the only method of gluing recommended by the
manufacturer.
|
